Foundry Networks FGS648P-POE Manuel d'utilisateur Page 82

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 96
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 81
FastIron GS Compact Layer 2 Switch Hardware Installation Guide
7 - 14 © 2007 Foundry Networks, Inc. September 2007
Figure 7.9 shows the location of the POE daughter cards on the main board of the FGS648P-POE.
Figure 7.9 Installing a POE Daughter Card in the FGS648P-POE
4. Re-assemble the device as instructed in the section “Re-assembling the Chassis” .
5. Power ON the chassis and observe the console. The following message will appear:
Info: PoE module detected in slot 1. Initializing....
6. Enable POE and configure POE parameters. See the Foundry FastIron Configuration Guide for information.
Re-assembling the Chassis
This section provides instructions for re-assembling the FGS device after removing, installing, or replacing a 10-
GbE module.
1. Replace the device’s cover by gently guiding the cover into place.
2. Once the cover is properly positioned, re-fasten the screws on each side of the cover.
3. If the device is rack-mounted, replace the mounting brackets.
POE Daughter Cards
Vue de la page 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 95 96

Commentaires sur ces manuels

Pas de commentaire